SINCE 1983,MANUFACTURER FOCUSED ON COMMERCIAL CARPET INTEGRATED SOLUTIONS

Home > News> News

News
Hot Product
Contact Us

Company:Wuxi Diamond Carpet Manufacturing Co.,Ltd

Email: wxdiamondcarpet@126.com

Phone:0086-510-82890779

Fax:

Address:Room 803, Jinxing Business Center, No.258 West Tiahu Avenue, Liangxi District, Wuxi, Jiangsu, China

How to Install Carpet Tiles

Carpet Tiles

Installing carpet squares, or carpet tiles, is not only easy but it is a simple way to add bold colors and patterns to a room. Best of all, the colors and patterns are easily customized to fit the decor of any home.
Materials and Tools:
carpet squares
carpet adhesive tape
utility knife
straightedge
tape measure
chalk line
pencil
Steps:

1. To determine the pattern (so a single tile will lie at the center of the room) determine the center of your room by finding the center of each wall. Measure the length of each wall and divide the length by two. Mark this midpoint with a pencil.

2. Measure the width of the tile and divide it by two. That will give you the center of the tile. Place the center of the tile at the wall’s center mark. Then mark the wall at each end of the tile. Repeat this process on the three remaining walls and then snap chalk lines from the marks to those on the parallel wall across the room. These four lines will create a cross hair at the center of the room.

3. Place the first carpet square in center of the cross hair and work tiles out from that center point. If the carpet squares have an adhesive backing, do not remove the cover from the backing yet. In the photograph chalk lines are highlighted with painter's tape to demonstrate the crossing lines used to center the first square.

4. Use multiple colored squares to create any pattern you like. Pull up and change the pattern at any time. Once the pattern is determined, remove backing from the squares and smooth into place.

5. The last step is to cut the carpet squares to fit at the wall. Turn the carpet square upside down and set it flush with the wall and mark at both ends where the carpet square overlaps the next to the last rows of full carpet squares. Use a carpenter’s square or straight edge and a utility knife to make a straight clean cut on the backside of the carpet tile. Install the partial square with the cut edge against the baseboard (molding will cover it if it is not exactly even).

------------------------------------------------------------------------------------------------------------------------------------This article is written by Wuxi Diamond Carpet Manufacturing Co., Ltd. Copyright Reserved. It is not allowed to be copied without permission. For reprinting, please declare the oringinal link. http://www.diamondcarpet.cn/

Contact Us

Wuxi Diamond Carpet Manufacturing Co.,Ltd.

E-mail: wxdiamondcarpet@126.com

Tel : 0086-510-82890779

Add:Room 803, Jinxing Business Center, No.258 West Tiahu Avenue, Liangxi District, Wuxi, Jiangsu, ChinaFactory Show



Wuxi Diamond Carpet Manufacturing Co.,Ltd

Technical support:baiila